AutoCAD Test

AutoCAD Test

 

Note:  Upwork AutoCAD Test questions are posted and answers will be updated soon. Please stay with us.


To enter relative Cartesian coordinates x,y (where x and y can be of any value) you can type:

a. <x,y
b. @x,y
c. &x y
d. =x,y


Which of the following is correct for POINT command?

Note: There may be more than one right answer.

a. Points objects can act as nodes to which you can snap objects.
b. You can specify 2D and 3D locations for a point.
c. You can use MEASURE and DIVIDE to create points along an object.
d. Use PTYPE to specify point size and styles.


To draw a line at specific angle of 45 after specifying a starting point you can type:

a. =45
b. @45
c. <45
d. ^45


To deselect an object from your selection set you need to:

a. Alt+Left Click on the object to be removed
b. Ctrl+Left Click on the object to be removed
c. Shift+Left Click on the object to be removed
d. Press ESC


You can use __ command to modify properties of existing object.

a. MODIFY
b. ATTRIBUTE
c. PROP
d. CHANGE


Which of the following is true for Fillet command?

Note: There may be more than one right answer.

a. A fillet is an arc that is created tangent between two 2D objects.
b. If the two selected objects are on the same layer, the arc defined is created on that layer. Otherwise, the arc is created on the current layer.
c. When a circle is selected, the circle is not trimmed; the fillet drawn meets the circle smoothly.
d. Fillet command can not be used with 2 overlapping circles


In order to move an object, ____

a. Select a base point,followed by a point to define where the object is moving to.
b. Use the Displacement option
c. Select object for grips, then move
d. All of the above


Which of the following is true about creating an arc?

Note: There may be more than one right answer.

a. If you press ENTER without specifying a point, the endpoint of the last drawn line or arc is used.
b. Arcs are drawn in a counterclockwise direction by default.
c. Hold down the Ctrl key as you drag to draw in a clockwise direction.
d. Hold down the Shift key as you drag to draw in a clockwise direction.


As you create or move objects, you can use __ to restrict the cursor to the horizontal or vertical directions relative to the user coordinate system (UCS).

a. Grid Snap
b. polar tracking
c. Ortho Mode
d. object snaps


Prev1 of 4

Share This Post